Residential Enclosures Archives

For surface mounting
Suitable for DIN-rail mounting devices up to 70 mm as MCB’s, RCCB’s, relays, switches, timers, contactors, etc
Manufactured from panel flat quality mild steel, cold reduced CR4 from 1.0 mm
Pre-treated prior to powder coating, fully immersed in iron phosphate solution
Electrostatic powder coating on a continuous line base colour RAL 7035
Slotted fixing holes on the base permit all leveling adjustment
Earth and neutral fitted to the base, each terminal being able to accept a 16 mm² stranded round conductor
With DIN-rails
Earth and neutral terminals standard
Distance between two DIN-rails: 150 mm
Generous wiring room
With plain grey or transparent door
Door opens 180°

For surface mounting
Suitable for DIN-rail mounting devices up to 70 mm as MCB’s, RCCB’s, relays, switches, timers, contactors, etc
Manufactured from panel flat quality mild steel, cold reduced CR4 from 1.0 mm
Pre-treated prior to powder coating, fully immersed in iron phosphate solution
Electrostatic powder coating on a continuous line base colour RAL 7035
Slotted fixing holes on the base permit all leveling adjustment
Earth and neutral fitted to the base, each terminal being able to accept a 16 mm² stranded round conductor
With DIN-rails
Earth and neutral terminals standard
Distance between two DIN-rails: 150 mm
Generous wiring room
With plain grey or transparent door
Door opens 180°

In accordance with EN60439-1 and IEC 439-1
Protection degree:
- IP40 – IK07 without door
- IP41 – IK08 with plain door
- IP41 – K07 with transparent door
Each DIN-rail can be equipped with 24 modules
Centre distance between two DIN-rails : 150 mm
Flush mounting depth : 105 mm
Can be equipped with the Record Plus 160A D-frame
Colour : RAL 7035

Electrical properties

Masking frame and door

Protection plate

Base

Ridged base (mono-block)
Manufactured in sendzimir zinc plated steel of 1 mm thick (F.O.R 144F)
Sidewalls foreseen with position lugs (F.O.R 144F)
Pre-treated prior to electrostatic powder coating in RAL 7035, light grey (F.O.R 144S)
Knock-outs in the upper, lower and the bottom side of the base
Fixing points for the fixation of cables with cable ties

Mounting frame

Door

Earth bar (L = 380 mm)

Flex-o-Box Junior

Suitable for surface mounting
2.5 mm² -500V
IP65 protection degree
Standards and approvals
- CEBEC : NBN C 68-685-2-0
- NBN C68-685-1
- VDE: 0606 Teil1
- KEMA: IEC 670
Colour: RAL 7035
Material: resists the 750°C incandescent wire test
Halogen-free
Operating temperature: 5°C to +60°C
Total insulation
Eight flexible entries
- 7 x ø20 in the side wall
- 1 x ø20 in the back
- Suitable for cable max ø20
- Suitable for tubes 5/8" and 3/4"

Flex-o-Box JB6

Protection degree: IP30
Masking frame, base and protective cover made from high resistance material
Metal door, powder coated, opens through 180 Â°
Cable entry from top, below, from side and from rear side
Cable entry plate (top, bottom) removable for easy cable mounting from front side
Clamp relief possibility
Sealing possible
Label for circuit identification
Rated voltage up to 400V/50Hz
Rated current up to 63A
Protection class II (total isolation)
Standards DIN 43871 and DIN VDE 0603 Part 1
For surface and flush mounting